Wind powered Turbine Energy

Navigation

You are here: Free Article Directory » Home-and-family » Home-improvement » Wind powered Turbine Energy

by: LawsonGutierrez | Total views: 5 | Word Count: 576 | View PDF | Print View
Share This Article

Why shouldn't I use automotive batteries in my DC system? Automotive batteries are meant to discharge a large amount of current in a very brief time. The lead plates are thinner and often porous to allow rapid discharge. They will also wear faster and are not intended to be discharged far below their normal voltage. True deep cycle batteries are intended for more moderate loading and deeper discharge, and are made with thicker, longer lasting plates.

How much wind is needed to make a wind generator worth it? Most residential sized wind generators need at least 5 to 8 mph winds to begin turning. Then, they need faster winds to begin producing at the “rated” output (i.e 1000 watts for a 1000 watt generator). This relationship of power to windspeed is shown by the power output curve seen in the wind generator literature. [back to top]The internal circuitry of the AIR is shielded and filtered to prevent radio interference, and has been tested to insure electro-magnetic compatibility.The AIR-X marine uses 1 1/2 schedule 40 steel pipe. (Actual outside diameter (O.D.) of the pipe is 1.

Will a stop swith not short my batteries? When a single pole, double throw switch that is rated for proper current and voltage is connected as shown in the manual, the turbine positive is disconnected from the batteries BEFORE being connected to negative. It is important that your stop switch be of the type that opens the circuit between positions. This is commonly referred to as a break-before-make switch. Be sure to install a fuse in any case.Welding cable is typically very finely stranded to be very flexible, where as standard cable will typically hold its shape.

What effect does radio interference have on the wind generator? The internal circuitry of the AIR is shielded and filtered to prevent radio interference, and has been tested to insure electro-magnetic compatibility.Most residential sized wind generators need at least 5 to 8 mph winds to begin turning. Then, they need faster winds to begin producing at the “rated” output (i.e 1000 watts for a 1000 watt generator). This relationship of power to windspeed is shown by the power output curve seen in the wind generator literature.

My wind generator is installed with an automotive-style amp meter, but I don't see any current. Why? Given that all wiring has been done correctly, and other precautions have been heeded, chances are that the amp meter is wired backwards and the needle is attempting to move in the negative direction. If zero is on the left-hand side of the meter, then the needle cannot move and looks as if the unit is not producing. Simply reverse the leads on the meter and see if current will register.The AIR-X normally does not affect radio transmitters. Care should be taken, however, to route power lines from the AIR-X away from the power and antenna lines of a radio transmitter.

Why shouldn't I use automotive batteries in my DC system? Automotive batteries are meant to discharge a large amount of current in a very brief time. The lead plates are thinner and often porous to allow rapid discharge. They will also wear faster and are not intended to be discharged far below their normal voltage. True deep cycle batteries are intended for more moderate loading and deeper discharge, and are made with thicker, longer lasting plates.Welding cable is typically very finely stranded to be very flexible, where as standard cable will typically hold its shape.
Share This Article